For the first project bike of the year, Wiseco has chosen the 2009 CRF450R. This fresh new racer is packed with loads of high performance goodies, including the latest and most advanced technology available.
We started with our bread and butter and upgraded the heart of the engine with our brand new 13:1 high compression piston. This piston is loaded with features and is built on a dedicated forging, so the strength-to-weight ratio is perfectly optimized for this application. In addition, the skirts are frosted Wiseco’s new ArmorGlide skirt coating for reduced friction, quiet operation, and extra insurance against cold scuffing.
To compliment the new heart of the engine, and to help it breath, we upgraded the lungs with an ultra-light full titanium Yoshimura RS-4 exhaust system. In this case the bark is as nasty as the bite, as the handsomely tuned system drew improved power delivery from the engine, giving it a very ride-able power band with nice increases over stock.
The most exciting part on the CRF450R is our new Fuel Management EFI Controller. Just like with a carbureted bike, to fully benefit from the changes we made to the piston and exhaust system, the fuel delivery needed adjusted. Obviously it is not easy to adjust the fuel delivery on a fuel-injected bike as easily as you can by swapping jets on a carbureted bike. . . until now! Wiseco’s new Generation 3.5 Fuel Management Controller allows the user to dial in the injector duration with the touch of a button. With simple plug-and-play installation, the user is able to select one of three tuning zones, that are synonymous with the pilot jet circuit, needle jet circuit, and main jet circuit on a carburetor. There is no laptop or external power supply needed! Once installed, the Fuel Management Controller can be used to select the necessary tuning zone, and then simply add or subtract fuel to maximize the power delivery, or optimize ride-ability. If that isn’t cool enough, we took the Fuel Controller one step further by coupling it with an external oxygen sensor mounted in the head pipe of the exhaust. This allowed us to run in full CLOSED loop mode, which maintains a specified air/fuel ratio at any given point in the RPM range, altitude, or temperature. Once the perfect air/fuel ratio is identified, our Fuel Management Controller will monitor the exhaust through the oxygen sensor, and hold the fuel delivery exactly at the programmed ratio.
To finish off the project bike, we installed our brand new 6-spring clutch, which includes a fully forged clutch basket, inner hub, and pressure plate, and Wiseco frictions, drive plates, and springs. The stock 4-spring CRF450R clutch has a heavy pull, and uneven spring clamping. The Wiseco design improves on that by offering a retrofit to the better 6-spring design, which evens the clamping load and lightens the pull at the lever.
We went with the CV4 radiator hose kit to eliminate the tee in the lines, and improve the quality and appearance of the stock hoses. Pro-Action took care of the suspension to ensure the bike handled as well as it ran. Renthal is handled the drive department with a R3 Gold O-Ring chain, Ultralite rear sprocket, and grooved front sprocket. Braking USA ensured the stopping power is up to par with a 270mm oversized front wave rotor and rear wave rotor. We used the Cycra M2 pivoting hand guard system for roost protection. Johnny Signs finished off the bike with a beautiful custom graphics kit highlighting the Wiseco-powered bike and supporting sponsors.
Wiseco has products for all the CRF450's, including high performance pistons; forged clutch components; clutch plates, springs, and covers; valve train components; and bottom end rebuild kits. Check out
http://www.wiseco.com/ProductSearch.aspx to find what we offer for you.
Posts
